Thanks for replies... I didn't expect there was much chance someone had this part just sitting in stock. I have access to a machine shop, and if this goes on much longer I may give it a try....especially not knowing the situation with the new ownership. Our R9's are such quality works of art I would prefer to have the original part. This situation was caused by My stupidity.....When I took my original grips off to put my new VZ's on- the pin holding the magazine release pulled out. After cleaning the gun I began to put the release pin back in... I was watching TV at the same time while sitting at my kitchen counter......my fingers slipped letting the spring shoot the release clip across the room. We have tore the room apart but no luck so far. I just can't believe I can't find it.....
I am concerned by the lack of any response from the new owners... I have called and sent an email...... I believe if Karl Rohrbaugh still owned it I would have at least received an acknowledgement and a timeframe the part would be back to me......by now.
One advantage I have is a 2nd R9S in my safe...a safe queen....but I hate to pull it out. I may use it as an example to make a new part, but carrying it everyday in my crossbreed holster will mark it up. I have ordered a custom IWB holster from Troy at Brigade GunLeather that will be much gentler on it and my original ..... If this goes on I can at least carry the 2nd one until the new owners get it together. Just very disappointed there is no response.....sets a bad tone for the change of ownership of such a great product.....but it's my fault I need the part..... Again, thanks for feedback.
