« previous next »
Pages: [1]

Author Topic: Looking to buy Take Down Tool  (Read 4260 times)

Offline geminidan

  • Expert
  • ***
  • Posts: 217
Looking to buy Take Down Tool
« on: June 23, 2009, 08:27:05 AM »
New R9 , looking for a good take down tool any suggestions????   tx Dan
Logged
GeminiDan

Offline MrsFosforos

  • Sharpshooter
  • **
  • Posts: 97
Re: Looking to buy Take Down Tool
« Reply #1 on: June 23, 2009, 06:58:01 PM »
IDMparts.com has RJ 2 in 1 tools listed in stock. One end is a slide stop and the other end holds the spring together for reassembly.
http://www.idmparts.com/index.php?cPath=1_25

For a punch, I use a glock armorer's tool.
Logged

Offline geminidan

  • Expert
  • ***
  • Posts: 217
Re: Looking to buy Take Down Tool
« Reply #2 on: June 23, 2009, 09:40:50 PM »
Thanks everyone for your help!! Dan :-*
Logged
GeminiDan

Offline onafile

  • New Member
  • *
  • Posts: 16
Re: Looking to buy Take Down Tool
« Reply #3 on: October 05, 2009, 07:22:45 PM »
Dan Any luck finding the ADM takedown tool??? I went to their site and it would not respond when I tried to click on the tool! Tom
Logged

Offline MrsFosforos

  • Sharpshooter
  • **
  • Posts: 97
Re: Looking to buy Take Down Tool
« Reply #4 on: October 05, 2009, 09:10:51 PM »
Quote
Dan Any luck finding the ADM takedown tool??? I went to their site and it would not respond when I tried to click on the tool! Tom

IDM hasn't kept the items in stock (which is disappointing considering they were the only ones making them); but there was a post a while back about making a similar takedown tool by drilling a piece out of the end of a toothbrush.  It might make do until someone else picks up the gap IDM has left!
Logged
Pages: [1]
« previous next »