The Rohrbaugh Forum

Rohrbaugh Products and Accessories => Rohrbaugh R9 (all variations) => Topic started by: eye_spy on September 29, 2010, 07:49:35 PM

Title: Frame gouging Question
Post by: eye_spy on September 29, 2010, 07:49:35 PM

Hey guys,

I have about 475 rounds through the pup now, and I was noticing a gouging in the front "horseshoe" if you will section of the frame under where the guide rod assembly is.  It is caused by the slide.

Anyone have this?

I am not under lubung.

Title: Re: Frame gouging Question
Post by: yankee2500 on September 29, 2010, 08:36:48 PM

Some pics would help everyone fully understand the problem.

John

Title: Re: Frame gouging Question
Post by: Richard S on September 29, 2010, 09:46:36 PM

The material at this link may be of interest:

http://www.acbsystems.com/boards/rohrbaugh/basefile/frame-wear.htm

Frame wear is self-limiting, with more than one R9 reported as having run through more than 5,000 rounds.

Title: Re: Frame gouging Question
Post by: kjtrains on September 30, 2010, 10:45:08 AM

Very good explanation and eye_spy, yours should not be a problem.

Title: Re: Frame gouging Question
Post by: eye_spy on October 04, 2010, 04:29:02 PM

Thanks for the info guys, I am relieved to have read that article. 8)