The Rohrbaugh Forum

Rohrbaugh Products and Accessories => Rohrbaugh R9 (all variations) => Topic started by: chasdo4 on February 22, 2009, 12:05:53 AM

Title: Sear Trigger Bar Coming Loose
Post by: chasdo4 on February 22, 2009, 12:05:53 AM

Recently, my Sear Trigger Bar (at the rear) is slipping underneath the hammer when I pull the trigger and I am not able to fire the pistol.  Any thoughts?  I have taken the right grips off and made sure the screws are tight.  The sear trigger bar spring is intact. Anyone else experience this?  Thanks for your thoughts.

Title: Re: Sear Trigger Bar Coming Loose
Post by: tracker on February 22, 2009, 12:26:39 AM

My thought is that is a factory issue started by a phone call.

Title: Re: Sear Trigger Bar Coming Loose
Post by: andyzx6r on February 22, 2009, 12:29:41 AM

If I remember correctly this can be caused by the hammer going just a hair to far forward.  If you pulled the hammer back just slightly it would re catch.  Of course that is hard to do with the slide on.   :-/

Title: Re: Sear Trigger Bar Coming Loose
Post by: DTM_39 on February 24, 2009, 06:17:34 PM

Andyzx6r,  What tracker said.  Could be the sear bar the spring or the hammer.  I'm sure Rohrbaugh will fix it.  Dan